17
© Vallox Oy - All rights reserved
•
Fan speed
— Indicates the fan speed. If the automatic
fan speed boost is turned on, the set value is shown in
brackets first followed by the actual fan speed.
•
HR cell status
— The statuses of the ventilation unit
heat recovery cell are:
• Heat recovery
— The heat recovery cell heats the air
streaming in from outdoors.
• Cool recovery
— The heat recovery cell cools the air
flowing in from the outdoors.
• Cell bypass
— The inflowing air bypasses the heat
recovery cell.
• Defrosting the HR cell
— The heat recovery cell is being
defrosted.
3. Proceed to the next phase by selecting
Right
arrow
.
The next information display of the mode shows the
following information:
•
Humidity
— Indicates the highest relative humidity of
air measured by the sensors.
•
Carbon dioxide
— Indicates the highest carbon dioxide
level measured by the sensors. If a VOC sensor has
been installed, it indicates the VOC level.
•
Replace filters
— Indicates the next recommended
filter replacement date.
•
Time in operation
— Indicates how long the device has
been running.
Browsing the Fireplace mode information
1. Open the main display of the fireplace mode:
2. Select
Mode information
.
3. The information display shows the following
information:
• Duration
— Indicates the duration of the set Fireplace
mode when the Fireplace mode is taken into use. The
value is expressed in hours and minutes.
• Remaining
— Indicates the remaining duration of the
Fireplace mode.
• Supply fan speed
— Indicates the percentage of the
supply air fan speed relative to the maximum speed.
• Extract fan speed
— Indicates the percentage of the
extract air fan speed relative to the maximum speed.
Editing the ventilation mode settings
1. Open the main display of the desired ventilation
mode.
2. Select
Mode information.
3. Select
Edit
.
4. Make the desired changes as instructed in the
section Setup wizard-> Ventilation mode settings.
USING THE UNIT
