Valley-Dynamo Jet-Pong Coin JP100, User Manual

Page: 75 / 80

72 | P a g e
3) Lift the Black Cable Tray cover mounted on the inside wall of the rear of the table (one on each side).
Check to make sure all LED strip connectors are plugged in and secure.
4) If the above does not work then replace the defective LED stripping in the T-Molding.
5) If the above does not work then replace the defective controller SP901E.
Symptom #10: Coin Mech(s) Faulty
CAUTION: This procedure requires the power to be on and the lid opened. When lifting the lid attach the Prop
Stick as a safety measure. (*CE Tables only)
1) Use the HMI
“Troubleshooting”
screen to test the Coin Mech(s). See instructions earlier in this chapter
for details.
2) Have someone insert a coin while you watch the LED inputs on the PLC Processor. The LED input
should flash when a coin is inserted. If not then check connections and cable harness from the PLC
Processor to the Coin Mech switch.
3) Make sure the number of coins required to start the game is properly set up on the
“Configuration”
screen discussed in Section 7.
4) If the Coin Mech LED is not working unlock and open the Coin Mech door. Check the connection and
cable harness to the Coin Mech LED light back to the PLC Carrier Board. Check for 12Vdc power at the
Coin Mech LED.
Symptom #11: Bill Acceptor Faulty
CAUTION: This procedure requires the power to be on and the lid opened. When lifting the lid attach the Prop
Stick as a safety measure. (*CE Tables only)
1) Use the HMI
“Troubleshooting”
screen to test the Bill Acceptor. See instructions earlier in this chapter
for details.
2) Have someone insert a bill while you watch the LED inputs on the PLC Processor. The LED input should
flash fast several times when a bill is inserted. If not then check connections and cable harness from the
PLC Processor to the Bill Acceptor. Check power to the Bill Acceptor.
3) Make sure the number of credits required to start the game is properly set up on the
“Configuration”
screen discussed in Section 7.
4) Make sure the number of pulses is set up properly on the Bill Acceptor itself.
5) Inspect the Bill Accepter to make sure it is not full or jammed.
Symptom #12: Credit System Faulty
CAUTION: This procedure requires the power to be on and the lid opened. When lifting the lid attach the Prop
Stick as a safety measure. (*CE Tables only)
1) Check the
“Configuration”
and
“Troubleshooting”
screens to make sure the proper number of credits
are starting the game. On Fridays/Saturdays check to make sure the number of credits for these days is
properly configured. If Friday/Saturday is not functioning properly then the main Processor battery
(CR1632 3V Lithium) will need to be replaced. It has a 5 year life expectancy. Then re-enter the time &
date and possibly any other important “
Configuration
”
info for your game.