Set-up 4
0020244995_02
ecoTEC
pro
Installation
and
maintenance
instructions
9
Information on the
data plate
Meaning
ecoTEC pro
Product designation
2H, G20
–
20 mbar
(2.0 kPa)
Gas group and gas connection pressure
as set at the factory
ww/yyyy
Date of manufacture: Week/year
Cat.
Permissible gas categories
Types
Approved gas-fired units
PMS
Permissible total overpressure in heating
mode
PMW
Permissible total overpressure during
domestic hot water generation
T
max.
Max. flow temperature
ED 92/42
Current efficiency directive fulfilled with
4* rating
V Hz
Mains voltage and mains frequency
W
Max. electrical power consumption
IP
IP rating
Heating mode
Domestic hot water generation
P
Nominal heat output range
Q
Heat input range
D
Nominal domestic hot water draw-off rate
Barcode with serial number,
7th to 16th digit = product article number
Note
Make absolutely sure that the product is compat-
ible with the gas group at the installation site.
3.3
Serial number
The serial number can be found on a plastic label at the bot-
tom of the front casing and on the identification plate.
3.4
CE label
The CE label shows that the products comply with the basic
requirements of the applicable directives as stated on the
identification plate.
The declaration of conformity can be viewed at the manufac-
turer's site.
3.5
Energy Saving Trust Endorsed Products
Only the most energy efficient products can carry the
‘Energy Saving Trust Endorsed Product’ brandmark making
it easy for consumers to choose products that have met strict
energy performance criteria.
Available for: Boilers, Heating controls and chemical inhib-
itors, the Energy Saving Trust endorsed product brandmark
gives consumers confidence that a product will cost less to
run, help lower energy bills and reduce carbon emissions.
About the Energy Saving Trust
Energy Saving Trust is an independent and impartial organ-
isation that provides trusted energy saving advice to em-
power millions of people to lead affordable, low energy life-
styles. For more information visit energysavingtrust.org.uk
3.6
Hot Water Association
Vaillant is a full member of the Hot Water Association and
promotes the scheme in association with its cylinder range.
Details are available on the web site www.vaillant.co.uk
4
Set-up
4.1
Unpacking the product
1.
Remove the product from its box.
2.
Remove the protective film from all parts of the product.
4.2
Checking the scope of delivery
▶
Check that the scope of delivery is complete and intact.
4.2.1
Scope of delivery
Num-
ber
Description
1
Heat generator
1
Installation kit containing the following:
1
- Product retainer
1
- Expansion relief valve connector
1
- Hot water connector
4
- Service valve
3
- Bag with small parts
1
Installation template
1
Condensate drain hose
1
Enclosed documentation
