Floor Screed Machine HD 50
41
www.utiform.com
departamento.té[email protected]
Tfno. + 34 96 570 29 82 Fax: + 34 96 570 29 83
9.3
Machine Safety indications
•
Never remove safety devices.
•
Never put your hand in the mixer tank when the machine is running.
•
Prior to starting any work ensure that no unauthorized person can connect the machine.
•
Only specialized personnel should carry out the work.
•
Avoid dirt in greased points. Wash the lubricator and the lubricating pump prior to use as the
dirt and sand in the bearings can cause premature wear.
•
Grease the machine after every cleaning operation.
•
Only use the recommended lubricants and never mix different brands as some lubricants are
incompatible, and the greasing effect will be considerably reduced.
•
Lubricate all moving parts not mentioned in the following chapter every six months
9.4
Battery Safety indications
•
The electrolyte in the batteries is a solution of sulfuric acid which, if it enters into contact with
them could seriously harm the eyes and skin causing burns, therefore it should be handled with
extreme care.
•
When the battery is charged it forms an explosive mixture of gas in the cells which is released
through the ventilation holes, so that an explosive atmosphere can form around the area of the battery
which may last several hours and therefore it is advisable
•
Not to smoke close to a battery under charge or recently charged.
•
Never to interrupt a powered circuit in the battery terminals as this will normally cause
a spark.
•
If an auxiliary battery is connected alongside (AB) by an amplifier cable with the
compressor battery (CB): join + de AB port with the + de CB port and then the – CB port
with the compressor mass.
When disconnecting carry out this process in reverse.
9.5
Daily lubricating points
If the machine does not have an automatic lubrication centre, or if it is out of order, the following points
require greasing.
1) Lubricate the seals of the mixer axle and the bearing of the mixer axle with the motor running twice a
day.
