Floor Screed Machine HD 50
8
www.utiform.com
departamento.té[email protected]
Tfno. + 34 96 570 29 82 Fax: + 34 96 570 29 83
13.
Control and clean regularly heat transmission surfaces (cooling blades, intermediate cooler, water
jackets etc.) so as to avoid temperature rise.
14. Carefully check all regulation and safety devices to ensure optimum operation. These must never be out
of service.
15. Avoid damaging safety valves and other pressure reducing devices. Be careful in particular with dirt
from the cement, fine sand or accumulated fibre, which could affect the operation of the devices.
16. Regularly check the pressure and temperature indicators. If acceptable limits are exceeded they should
be changed.
17. Use only original
Utiform
replacement parts.
18. In order to check the perfect state of the safety devices, you should follow the steps indicated in the
maintenance plan in the instruction manual.
19 DO NOT use flammable solvents, combustible Diesel or carbon tetrachloride to clean parts. Apply safety
measures for protection against noxious vapor from cleaning products.
20. Take extreme care when cleaning during repair work. Avoid dirt by covering parts and openings with a
clean cloth or masking tape.
21. Protect the motor, alternator, air filter, electrical components, regulation devices etc. against damp when
steam cleaning.
22. If you have to carry out work on a machine which causes heat, flames or sparks, the nearby
components should be protected with anti-inflammatory material.
23. Never check the inside of the machine, a pressure vessel etc. using a light with a flame.
24. Place the traction bar and the axle(s) in safe position in moveable machines, if you are working
underneath, or remove a wheel. DO NOT rely on jacks.
25. Prior to dismantling or servicing a HD50/07, motor or any other machine, ensure that all moving parts
weighing over than 15 kg cannot roll or move in any way.
26. When you have finished the repair work, always check that no tools, loose parts or cleaning rags have
been left on top of the machine, on the drive motor or on any other activating mechanism.
Check the direction of the rotation of the electrical motors at every start up and after every change in
connections or electrical repairs, to ensure optimum effect of the oil pump and the ventilator
