NX-7002N Installation Manual
Page 48
05/06/13
I
NSTALLATION GUIDELINES
Avoid installing the module:
-
Where temperatures exceed 49°C or fall below 0°C.
-
In the immediate vicinity of electronic equipment.
-
In humid rooms. The module is not hermetically sealed and excess moisture on
the circuit board can eventually cause an electrical fault.
Keep the antenna within 2 m of the panel.
The antenna is to be mounted an appropriate distance from people, i.e. more than
200 mm.
Before permanently mounting the module, test it at the intended location to ensure
that the remote alarm receiver can receive signal transmissions. There may be blind
or non-operational locations within the installation. Normally these can be overcome
by moving the antenna.
Note: To test the signal strength at the intended location, insert the SIM card into a
mobile phone and check the strength indicator on the mobile phone.
M
OUNTING THE
NX-7002N
Inside the can, several 2-holed insertion points have been constructed. This allows for
either vertical or horizontal placement of the modules. Notice that each insertion point has
two sizes of holes -a larger hole and a smaller hole.
Diagram 1
: The black plastic PCB guides are grooved on
one edge where the PC board will be seated. The end with
the half-moon protrusion fits into the larger hole. The
smaller hole is for the screw.
Diagram 2
: Place the
first
black plastic PCB guide in the top
insertion point, grooved edge downward. The half-moon
protrusion will be in the large hole. It does not require force.
Insert one of the provided screw into the smaller hole (from
inside the can) to secure it in place. A screwdriver should
reach through the notch that runs the length of the guide to
tighten the screw. The
second
PBC guide should be
positioned opposite the first (grooved edge up) and placed
in the lower insertion point, using the same procedures
described above. Once mounted, screw it in securely.
Diagram 3
: The module should slide freely in the grooves of
both guides.
Summary of Contents for Interlogic NetworX NX-7002N
Page 15: ...NX 7002N Installation Manual Page 15 05 06 13 ...
Page 55: ...146306999 5 ...
