NX-7002N Installation Manual
Page 11
05/06/13
S
TART UP
,
ENROLLING AND TESTING THE
NX-7002N
1.4 Inserting the SIM card
Note: You must be free of all static electricity when handling electronic
components.
Always power down the system before inserting a SIM Card.
Locate the SIM card holder
on the board.
Open the SIM card holder by sliding the metal clip as shown in
and lifting the
holder.
The SIM card holder opens
.
Slide the SIM card into the holder using the guides. Make sure the contacts (gold
pads) face the circuit board and the angled corners face out
.
Ensure the SIM card is inserted correctly in the holder and close the SIM card holder
.
Slide the metal clip back to the original position as shown in
.
Power up the system. Do not enter programming mode until the SIM card selects the
network operator. The SIM card automatically selects a network operator when
enrolled on the network. To manually select an operator, enter the relevant network
operator in location 170. See
Appendix 2: Operator ID Codes
for a list of operator ID
codes. Most SIM cards contain a pre-programmed SMS service centre address and
under normal circumstances, this should not be changed. If you do need to change
it, include the international country prefix using a '+' instead of leading zeros.
Program ‘13’ to insert ‘+’ in the address.
OPEN
LOCK
Summary of Contents for Interlogic NetworX NX-7002N
Page 15: ...NX 7002N Installation Manual Page 15 05 06 13 ...
Page 55: ...146306999 5 ...