UTAH SCIENTIFIC Utah-400 iP, System Setup And Operations

Page: 84 / 146

Utah-400 Components
4-16
The Utah-400
The small modules are responsible for the electrical-optical conversion, and are removable if
service is required.
FIGURE 4-16.
SP2T - Transmitter module
The SP2R is the receiver module, and is a part of the larger Input card assembly. The SP2T is
the transmitter module, and makes up the Output card assembly. These modules are removed
and replaced by moving the swinging bale (at the end) out of, and back in to the locked posi-
tion.
The system’s input and output
totals
are typically defined prior to equipment setup and opera-
tion. This is based on the number of total fiber inputs.
Specification Detail
•
Optical Fiber Output – 1310 nm class 1 laser.
•
Optical Output Power - -12dB minimum
•
Optical Fiber Type – 9/125 uM Single Mode Fiber
•
Connector Type - LC
•
Typical Cable Length – 18 Miles SD, 10 Miles HD
•
Optical Fiber Input – 1310 nm Class1 laser
•
Optical Input Power - -20dB min
•
Optical Fiber Type – 9/125 uM Single Mode Fiber
•
Connector Type - LC
•
Typical Cable Length – 18 Miles SD, 10 Miles HD