UTAH SCIENTIFIC Utah-400 iP, System Setup And Operations

Page: 125 / 146

144x144 Router
B-3
The Debug Cable
The Debug Cable
The Debug Cable is a full duplex serial cable, consisting of an RJ-45 Connector on one end
and DB-9S (female) connector at the other end. Refer to the figure below if you wish to build
your own cable for the debug port.
FIGURE B-1.
Debug Port Cable Pinouts
The terminal settings for the debug port are: Baud Rate = 38.4 K baud; 8 Data Bits; 1 Stop
Bit; No Parity; ASCII Translation and CR = CRLF (carriage return, line feed).
The Hyper-Terminal will have the same settings as above; but since the Hyper –Terminal does
not have a CRLF setting a similar parameter is set by doing the following:
•
Click on “Open Port” and set the Baud Rate, Parity, and Stop Bits.
•
Select “None” in the Flow Control Box”, Click “OK”.
•
On the Hyper-Terminal window select “File”, click on “Properties”.
•
Click the “Settings Tab” in the Properties Window.
•
Click the “ ASCII Setup ” Button.
•
In the “ASCII Receiving Block” at the bottom of the window, checkmark (enable) the
“ Append Line Feed to Incoming Line Ends ” and “ Wrap Lines that Exceed Terminal
Width ”. These parameters perform the same function as the Terminal’s CRLF Setting.