UTAH SCIENTIFIC Utah-400 iP, System Setup And Operations

Page: 5 / 146

Setup and Operations Guide
v
•
Dangerous voltages exist at several points in this product. To avoid personal
injury, do not touch exposed conductors and components while power is on. Do
not insert anything into either of the systems two-power supply cavities with
power connected.
•
Do not wear hand jewelry or watches when troubleshooting high current cir-
cuits, such as power supplies. During installation, do not use the door handles
or front panels to lift the equipment as they may open abruptly and injure you.
•
To avoid fire hazard when replacing fuses, use only the specified correct type,
voltage and current rating as referenced in the appropriate parts list for this
product. Always refer fuse replacement to qualified service personnel.
•
Have qualified personnel perform safety checks after any service.
Cautions
Please observe the following important cautions:
•
When installing this equipment do not install power cords to building surfaces.
To prevent damage when replacing fuses, locate and correct the problem that
caused the fuse to blow, before reconnecting power.
•
Use only specified replacement parts
Notices
Please observe the following important notes:
•
When the adjacent symbol is indicated on the chassis, please refer to the man-
ual for additional information.
•
For the HD-2020 Chassis and Master Control Panel, refer to “Connecting and
Disconnecting Power” - Chapter 2 (Hardware Installation).