2
Unpacking/Inspection
……………………………………………………………………………
2
Safety Guide
………………………………………………………………………..……………..2
Proper Installation
……………………………………………………………………..………….3
Introduction
………………………………………………………….……………….……………3
System Overview and Specifications
…………………………………………….………..……4
How The Matrixx inFusion Treatment System Works
…………………….…………….….…5
Matrixx Installation Instructions and Specifications
…..……...……………………...…....….6
Tank and Control Valve Preparation
……………...…………………..………………..….…...6
Infusion Tank and Control Valve Preparation
………………………………………………….7
Water Meter Installation
…………………………………………………………………….…….8
Tank and Control Valve Connections...
………………………………………………...……...10
New Sounds
………………………….....………………..…...………………………….………12
Automatic Hard Water Bypass During Regeneration
……………………………….………..12
Manual Bypass
……………………………………………………………………………………12
Chemical Solution Tank with Pump Mounted
……………………………………………...….13
Chemical Pump Wiring for Tank Mounted System
…………………………………………...17
Chemical Injection Pump Start
-
up Instructions
………………………………………………..18
System Regeneration Using Onboard Buttons
…………….……………………….......……19
Programming Using Onboard Buttons
……………………………………………...……….....20
Programming Using Water Logix App
………………………………………………………….21
System Start
-
up Instructions
……………………………………………………….…………...26
H2O2 Injection Pump Adjustment Instructions (Bubble Method)
…………………………...27
Infusion Carbon Filter Valve Battery Backup
………………………………………………….28
What To Expect and Routine Maintenance
……………………………………….….............29
Maintenance Schedule
…………………………………………………………….……............30
Limited Lifetime Warranty
……………………………………………………….……..……..…31
Safety Guide
Be sure to check the entire system for any shipping damage or parts loss. Also note damage to the shipping
cartons. Contact US Water Systems at 1
-
800
-
608
-
8792 to report any shipping damage within 24 hours of de-
livery. Claims made after 24 hours may not be honored.
Small parts needed to install the system are in a parts bag. To avoid loss of the small parts, keep them in the
parts bag until they are used.
Unpacking / Inspection
•
Check and comply with provincial / state and local
codes and follow these guidelines.
•
Use care when handling the iron removal system.
Do not turn upside down, drop, drag or set on
sharp protrusions.
•
The backwashing carbon filter uses 12 volt
-
60 Hz
electrical power only. Be sure to use only the in-
cluded transformer.
•
Transformer must be plugged into an indoor 120
volt, grounded outlet only.
•
WARNING
: This system is not intended for treating
water that is microbiologically unsafe or of un-
known quality without adequate disinfection before
or after the system. Contact US Water Systems for
disinfection treatment equipment.
Table of Contents
