urmet domus Note 2 1723 Series, Configuration Booklet

Page: 12 / 48

12 DS1723-024
Follow the connection diagram below on the master video door phone to connect one or more motion sensors
(in series).
WARNING. Speci fi c settings are required in the ‘Con fi guration’ menu to use a motion sensor’
(6)
.
Finally, if you want to provide an alarm signal on a siren (e.g. Urmet siren 1033/414), connect the siren to blue
wires (SPARE RELAY ) of the master video door phone.
Power supply
230 Vac
Blue wire
Blue wire
Black wire
Red wire
Supplementary
power supply
Ref.1063/901
Siren
NC ALL
+_
NC ALL
+_
Motion
sensors
~
~
+
-
230V
~
WARNING. Speci fi c con fi gurations steps are required to use of motion sensors and the siren.
In the ‘Con fi guration’ menu which can be opened using the icon on the top right, select the ‘Installer’
menu, type in the password (‘1937’) and select ‘Alarms’.
Most options relating to the alarm operating mode can be set in this way.
In particular, the following can be de
fi ned:
The exit and entrance times:
Exit time: no alarm is generated if the sensor is energised during the exit time.
Entrance time: with the alarm armed, the energising of the sensor will generate an alarm only after the entrance
time.
To which devices to send an alarm signal .
Enabling the alarm signal on the video door phone speaker.
Enabling the alarm signal on a siren connected to the video door phone.
WARNING: Contact 2 must be con fi gured as ‘Alarm Siren’.
Enabling of the alarm signal to simulate the pressing of a home automation button
(7)
. For example, the garden
lights can be switched on if there is an alarm.
Enabling the sending of the alarm signal to the CallMe app. In this case, the system must include an appropriately
con
fi gured call forwarding device Ref. 1723/58.
—
—
—
—
—
—
(6)
The use of motion sensor precludes the possibility of connecting a local camera to the video door phone: the
two functions are mutually exclusive.
(7) NOTE: Once having set a home automation button to be recalled in case of alarm signal, it will no longer be
editable within the home automation settings (it will be greyed out). So, you must con fi gure the button (e.g. to
connect it to the module Yokis and set the ON function to turn on the light) FIRST and THEN assign it to the
alarm signal.