BRACKET CONFIGURATION
http://www.miwiurmet.com.pl e-mail:[email protected]
60
OPERATION
VIDEO AUDIO-ON
Video audio-on function demands one additional wire in the
installation between bracket’s terminal R3 and terminal R in the call
module. Principle of operation is connecting R3 to the GND as long
time as video door phone is active.
For activating video auto-on function set S3 dip-switch to VIEW
position.
Video auto-on is possible only if system is in stand-by mode
(without calling, conversation and other video auto-on).
Video auto-on is activated by
button without picking up the
handset. The video will be turned off automatically within 15
seconds or in case of any call.
SWITCHBOARD CALL (OR OC CONTROL IN SYSTEM
WITHOUT SWITCHBOARD)
For activating switchboard calling function set S3 dip-switch in the
VIEW position.
Lift
the
handset
and
press
button in order to call the switchboard.
OPENING THE DOOR WITHOUT PICKING UP THE HANDSET
Video door phone system (as opposed to door phone system)
allows opening the door without picking up the handset.
FLOOR CALL
For activating floor call set S2 dip-switch in the RING position.
In this case
button will be deactivated, but its terminals Y1 and
Y2 became an output for external bell-push. Connection Y1 and Y2
together will be activated floor call ring in the video door phone.
SELECTING CALLING TONE
The bracket is equipped with 3 calling tones.
To select calling tone press and hold door opener button and press
the
button (must be set in video auto-on function). The video
door phone will play the first tone. Next pressing the
button will
change the tones. Simply release the door opener button when the
required tone is playing.
DETECTION OF VIDEO SIGNAL
Thanks to detection of video signal, monitor will be activated only if
video signal is present and has good quality.
If detection is turn ON, monitor will not be activated just in case:
- calling from switchboard,
- calling from audio call module,
- camera is not connected or faulty,
- fault of installation
TECHNICAL SPECIFICATION
Voltage:
Power supply (R1, R2)
18 V DC
Line 0L-LG
+7,5...12,5 V DC
Video signal A-B
6,5 Vpp
Video signal V3
1 Vpp
Operating temperature
0
°
C
÷
+50
°
C
INSTALATION
1.
Arrange the duct so that it ends in correspondence with one of
the input holes.
2.
Fasten the bracket to the wall at the height from the floor
shown by means of the four screws.
3.
Connect the wires to the specific terminals
4.
Extract the retainer hook A by inserting the tip of a screwdriver
and pulling the hook downwards.
5.
Fasten the video door phone to the bracket as shown.
6.
Fasten the video door phone by pushing the retainer hook A
upwards.
