PROGRAMMING MODE
http://www.miwiurmet.com.pl e-mail:[email protected]
39
4.03 GENERAL OPENING CODES RESTORE
P 4 0 3
To activate this function please press
button. During this process
on LED display will be shown this communication:
- - - -
4.04 ALL DATA RESTORE
P 4 0 4
This function restore:
•
individual opening codes
•
general opening codes,
•
logical user codes,
To activate this function please press
button. During this process
on LED display will be shown this communication:
- - - -
4.08 EEPROM MEMORY DELETING AND RESET
P 4 0 8
This function restores default settings of all programming steps and
logical user code (logical user code re-mapping will be lost).
To activate this function please press
button. During this process
on LED display will be shown this communication:
- - - -
In the end of this process power supplier will RESET.
4.09 DEFAULT SETTINGS P1 P2 AND P7 RESTORE
P 4 0 9
This feature applies to restore:
•
Restore main setup,
•
Restore times,
•
Advanced functions.
To activate this function please press
button. During this process
on LED display will be shown this communication:
- - - -
5. LOGICAL USER AND OPENING CODES
5.01 LOGICAL USER CODES PROGRAMMING
P 5 0 1
After pressing the
button on the LED display will be shown this
communication:
C F F F
C
riser number (1 or 2)
FFF
physical code (set by jumpers set in the house phone in
the range 1-255
Logic user code can be associated to every physicla user code set
in the house phone (physical code). To do it:
•
Enter the number of riser to which house phone is connected,
•
Enter physical code of the house phone,
•
Confirm by pressing the
button
If the physical code was not associated with any logical user code
on the LED display will be shown this communication:
L L L L
If physical code has been already associated, than on the LED
display will be shown programmed code.
Than we are able to:
•
Keep previous code or enter new one in range from 1-9999,
than confirm,
•
Confirm entered code by pressing and hold for a while the
button. If we just press the
button than the system will
propose first free logical user code, we can confirm by pressing
and holding
button, or just press the
button to continue
searching.
Searching process of first free logic code will be shown on LED
display with this kind of communication:
- - - -
In every moment of programming we are able to stop by pressing
the
X
button.
Logic code can be associated just to the one physical code.
If we will try to program physical code to existing logical code, than
call module will play short warning signal and start blinking existing
physical code on the LED.
Than we are able to:
•
Hold the button
, what will overwrite logical code from
existing to valid physical code,
or
•
Press the button
X
, if we would like to return to the place
where we can offer new logical code to program.
Default settings
For riser 1- codes in range from 1 to 255
For riser 2- codes in range from 256 to 510
