urmet domus Miwi 1032/9, Manual

Page: 27 / 98

MOUNTING PANELS 1052/11 AND 1052/16
http://www.miwiurmet.com.pl e-mail:miwi@miwiurmet.com.pl 27
MOUNTING PANELS 1052/11..11D AND
1052/16..16D
Important: The module should not be illuminated from behind to
make the calling module display easier to read. Never direct the
module towards strong sources of light.
ASSEMBLY NAME TAGS
Name tag consist of 2 perspex plates (one see-through and one
lustreless). Put information tag between plates, see-through plate
on the outside.
1.
Take out front panel of the information module.
2. Slide out 2 plates.
3. Put information tag between plates.
4. Slide in plates, fasten the front panel.
WALL-MOUNTED VERSION
1. Take out the front keyboard panel.
2. Take out the front panel of the information module.
3. Disconnect terminal X2 (speaker), X10 (Dallas key reader),
X12 (backlight information panel) Fig. 4.
4. Take out the PCB assembly kit (move up bottom part and slide
out).
5. Take out the backlight plate (2 screws in the bottom part).
6. Fit the cable through the hole B. Fig. 6.
7. Fasten the case to the bottom using 4 holes A. Fig. 6.
8. Fit the backlight plate.
9. Fit the cable through the hole in PCB assembly kit.
10. Slip the PCB assembly kit into latches located in the top part of
the case.
11. Press down part of the PCB assembly kit.
12. Connect the wires.
13. Connect terminal X2 (speaker), X10 (Dallas key reader) and
X12 (backlight information panel). Fig. 4.
14. Close and fasten the front keyboard panel.
15. Close and fasten the front panel of the information module.
Fig. 4 (PCB assembly kit).
FLUSH-MOUNTED VERSION
For flush-mounted version is recommend using the frame
Ref. 525/RP3.
1.
Take out the front keyboard panel.
2. Take out the front panel of the information module.
3. Disconnect terminal X2 (speaker), X10 (Dallas key reader),
X12 (backlight information panel) Fig. 4.
4. Take out PCB assembly kit (move up bottom part and slide
out).
5. Take out the backlight plate (2 screws in the bottom part).
6. Fit the frame 525/RP3 in the wall.
7. Fit the cable through the hole B. Fig. 6.
8. Fit the case in the frame, fasten the case to the bottom using 4
holes A. Fig. 6.
9. Fit the backlight plate.
10. Fit the cable through the hole in PCB assembly kit.
11. Slip the PCB assembly kit into latches located in the top part of
the case.
12. Press down part of the PCB assembly kit.
13. Connect the wires.
14. Connect terminal X2 (speaker), X10 (Dallas key reader) and
X12 (backlight information panel). Fig. 4.
15. Close and fasten the front keyboard panel.
16. Close and fasten the front panel of the information module
Fig. 6.