DS1093-520
23
3.4.1.4
Output
On this page of the Display menu you can configure the main video output parameters of the DVR.
Video output:
Select the video output used by the DVR; possible values: LIVE-OUT.
Seq Mode:
It is possible to set the Layout for the cycle function; possible values are: Layout1, Layout4, Layout9,
Layout10, Layout10-1, Layout12, Layout13, Layout13-1, Layout14, Layout16, Layout19, Layout20, Layout22.
SEQ Dwell Time:
Time interval of the Sequence function. Value is set as 5 seconds default. User can change
the option as per request. The minimum time that can be set is 1 second.
VGA/HDMI Resolution:
allow you to select VGA or HDMI output resolution. Default Value: 1920x1080.
Transparency:
allow you adjust OSD menu’s transparency, and its range is 1~128. Increasing the value will
increase transparency as a consequence
Support Overscan:
if the picture can not display full on some monitor, like can not see the menu bar, then
enable this function, it can make the picture display fully on the screen.
3.4.1.5
Image Control
This item of the Display menu can be used to access the page for adjusting the IP camera image quality parameters. The
following figure shows a typical example and the meaning of the available options is described in the following list.
Warning:
The available options may differ according to the IP camera model.
Channel
: this is used to select the channel number.
IR-CUT Mode:
this is used to set the mode for using the infrared filters for colour balancing when shooting in
daylight; three modes are available: Auto GPIO, Colour, B/W.
IR-CUT Delay:
delay time for IR-CUT filter operation; possible values: from 1 to 36.
Lens Flip:
to flip the image vertically on the screen (up
down).
Angle Flip:
to flip the image horizontally on the screen (right
left).
Angle Trad:
to set the flip angle of the image.
Back Light:
this is used to switch the backlight function on.
Summary of Contents for Hybrid DVR 1080N Series
Page 107: ...DS1093 520 107...
