8
−−−−
sec.3g
2 VOICE - Technical Manual
ELEKTA AND ELEKTA STEEL CALL MODULE
Select the behaviour of DOOR LOCK 1
with the
buttons and press
OK
to
con
fi
rm.
See the Parameter table for more
information on FREE and SECRET
mode.
Set the release time of door lock 2 (relay
actuation, terminals SE2) on the keypad
and press
OK
to con
fi
rm the selection.
Permitted values: 0 ÷ 90 seconds, with 1
second increments.
If the time is set at 0 seconds,
the opening of the door is
disabled. It is not possible to
program both the opening
times of door opener 1 and of
door opener 2 at 0 seconds.
Select the behaviour of DOOR LOCK 2
with the
buttons and press
OK
to
con
fi
rm.
See the Parameter table for more
information on FREE and SECRET
mode.
Modify the default calling module
PASSWORD by entering a new four-digit
code using the keypad and pressing the
OK
button to con
fi
rm.
Press
X
to cancel an incorrect digit.
Permitted values: 1000 ÷ 9999.
Select the LCD BACKLIGHT level of the
display with the
buttons and press
OK
to con
fi
rm.
1 = darker, 5 = lighter
Select whether the calling module must
generate a feedback tone when a button
is pressed using the
buttons and
press
OK
to con
fi
rm.
Enter the physical code of the extension
where to route the call generated by
pressing at least three buttons at the
same time (multitouch or emergency
call) if the system is not provided with
concierge switchboard or if this is present
but con
fi
gured in NIGHT mode.
Press
OK
to con
fi
rm the entered code.
Type in the WELCOME MESSAGE on the
keypad and press
OK
to con
fi
rm.
The message may consist of two lines
of up to 16 characters each. Move the
cursor using the
buttons.
Press
to go to the next
line to enter a word less than
16 characters long.
This screen allows you to view or set the
system TIME ZONE. The default value is
empty and corresponds to the reference
time zone UTC. To specify a different
value, select with the button YES and
con
fi
rm with the
OK
button. If you con
fi
rm
with
OK
button the NO option, it will be
shown directly the screen for DATE AND
TIME setting.
This screen shows time zone value after
default value has been changed.
2VOICE ELEKTA CALL MODULE Ref. 1083/15 (50Hz) – 1083/25 (60Hz)
2VOICE ELEKTA STEEL CALL MODULE Ref. 1083/16 (50Hz) – 1083/27 (60Hz)
PROGRAMMING
(*Annex)
(*Annex)
(*Annex)
(*Annex)
(*Annex)
(*Annex)
(*Annex)
(*Annex)
(*Annex)
