DS1092-121
77
4.2.1
CONTROL KEYPAD PASSWORD AND ACCESS
The system will wait for the password to be entered after being switched on.
The control panel requires a 6-digit password.
The entered digits will be replaced by a “*” symbol on the screen for privacy.
Access to the menu is gained after entering all the digits correctly.
Refer to the corresponding manual for using the control panel.
e
IMPORTANT NOTE
THE DEFAULT USER PASSWORD IS “000000”.
It is advisable to change the default password to prevent intrusions.
Do not lose or forget the programmed password.
Take note of the new password and keep it in a safe place.
4.2.2
CONTROL KEYPAD COMMAND SYNTAX
Controls can use the joystick, single keys or key combinations.
The key command syntax is shown below.
Key command syntax
The syntax used in this manual for controls using keys consists of various elements (words and three digit numbers).
Each command is always in braces and each element is separated by commas. Each word or decimal digit used in the
syntax is identified by a corresponding key on the 1092/693-694 control panel. Words can be enclosed in round brackets,
square brackets or no brackets. Three digit decimals are never enclosed in brackets.
The following words only can be used:
PRESET, SHOT, ADDR, ESC, IRIS+, IRIS-, FOCUS +, FOCUS -,
ZOOM -, ZOOM +, ENTER
. The decimal digits are:
0, 1, 2, 3, 4, 5, 6, 7, 8, 9
.
Some application examples of controls are shown in detail below.
Using the joystick
A command can also be given simply by moving the joystick because this generates actions on the camera or OSD (On
Screen Display) menu.
e
IMPORTANT NOTE
The joystick also allows to stop an operation during its execution; to do this, move the joystick in any direction
to stop the operation in progress; in this way it is possible to start another one or send a command.
Using a single key
Pressing a single key can cause camera action. For example, the following command will zoom out of the frame.
Underling indicates the key is in use.
ZOOM -
Key combinations
Pressing a key combination in rapid sequence extents the command set. For example, the following command (select
camera address 1) is performed by pressing the following keys:
CAM + 1 + ENTER
4.2.3
CONTROL KEYPAD COMMAND TYPES
There are four command types.
1. Select
camera.
2. Move camera (tilt and pan, zoom, adjust focus and iris opening, go to preset positions).
3. Adjust camera operation mode using menus.
4. Various quick controls operable from the control panel.
The method for accessing these controls will be shown in detail in the following paragraphs.
Summary of Contents for Easy Dome IV 1092 Series
Page 115: ...DS1092 121 115...
