53
DS1168-013C
ACCESS PASSWORD
The configuration button (43) can be protected by means of a 3-digit password.
When the device password is entered, subsequent accesses using the setup button are only possible by entering
password again.
ATTENTION:
If all the MASTER keys of a device equipped with password are lost and you have forgotten the password, IT
IS IMPOSSIBLE TO ACCESS DEVICE PROGRAMMING. In this case, get in touch with the URMET technical
assistance service directly which will eliminate the password without deleting any of the user keys.
The password can be set on any device without password (therefore on any device that leaves the factory). Once
the password has been entered, it cannot be modified. It can be deleted only using the complete memory reset
procedure (see below): IT IS ADVISABLE THEREFORE TO ENTER THE PASSWORD BEFORE STARTING TO STORE
THE USER KEYS SO THAT THIS CAN BE DELETED IN THE CASE OF ERRORS DURING THE ENTRY PHASE.
Proceed as follows:
• press the configuration button briefly
;
• wait until the following is displayed:
• press the configuration button and
keep it pressed
. The following will appear on the display:
and the first bar increases by one unit, approximately once a second, cyclically (i.e. moving from 9 to 0).
• Release the key when the digit you want to set is displayed.
• Press and release the rear key again twice so as to set the other two digits. Now the display will show the
configured password. Press the rear key briefly to confirm the password. In this way, you will access the
MASTER key programming menu from which you can exit using a MASTER key as described in the chapter
‘
Key master key storage
’.
4.2.4 ERROR CODES
The meanings of the error codes that may be displayed during programming are given below:
A key not produced by Urmet has been presented to the front panel.
Key memory full.
An attempt is being made to delete a key not present in the memory.
Key memory absent or faulty.
Key memory data consistency error.
Write to memory error.
5 RESETTING THE CALL MODULE
To restore the parameters of the call module to the default values, reset the devices that make it up in the
following order:
1) Audio door unit module (Ref. 1083/38 or 1083/39) or audio-video door unit (Ref. 1083/48)
• Press the reset button (PROGRAM) (11) briefly to go to configuration state. The LEDs (1) will blink during
this step.
