44
DS1168-013C
You can switch between the devices by pressing the
or .
The following labels indicate instead:
1. The value of the parameter ADVANCED CALL BUTTON CONFIGURATION previously set.
: The association of the buttons to the columns and apartments in the system if (as in this case)
automatically or in mode
(see point B).
2. The value of the previously set DOOR UNIT TYPE parameter.
: The DOOR UNIT TYPE is main (as in this case) or
.
B This area shows the list of buttons present on the device and their association with the columns and apartments
present in the system.
If the ADVANCED CALL BUTTON CONFIGURATION was previously enabled, the function of the
button can be changed by choosing from the following parameters:
– CALL APT (call apartment)
– CENTRAL Switchboard
– SPECIAL FUNCTION (activate special decoder)
– NOT ASSIGNED
You can configure a button for a special function, such as turning on the staircase light.
At the button you want to configure, press the “Function” drop-down menu, select the “Special function” item
and assign the code you want to send.
The special function will only be activated if a specially programmed special decoder has been
installed.
4.1.3 DISPLAY MODULE PAGE
This page (which appears a
s s
hown in figure below) can be used to configure the display module Ref. 1168/1 and
customise the user directory associated with it.
WARNING!
If the firmware version of the display Ref. 1168/1 is the
2.0.0-14
or higher, the following additional
features can be used:
- new configurable welcome page that can be displayed during display stand-by;
- new type of “Private” users;
- availability of new languages for the display interface.
See chapter 4.1.4.1 DISPLAY REF. 1168/1 MODULE FIRMWARE UPDATE to update the firmware of Display
Module Ref. 1168/1.
On the page
DISPLAY PARAMETERS
you can change:
