DELAY (HOURS)
In this menu the number of delay hours, used to switch
meltaway state from STOP to IDLE, is set.
To set the delay:
1. Select
Delay (hours)
.
2. Press the navigation wheel to confirm selection.
3. Set the value.
Default: 1 hour
Setting range: 0 – 24 hours, 1 hour increments
4. Confirm the new setting by pressing the navigation
wheel again.
DELAY SURFACE DRY
In this menu the number of delay days, used to switch
meltaway state from MELTING to IDLE, is set.
To set the dry surface delay:
1. Select
Delay Surface Dry
.
2. Press the navigation wheel to confirm selection.
3. Set the value.
Default: 0 days
Setting range: 0 – 2 days, 1 day increments
4. Confirm the new setting by pressing the navigation
wheel again.
Enter Idle State Conditions
This menu enables access to parameters used when to
switch the meltaway state in the zone to and from IDLE.
The zone switches from STOP to IDLE state when the
measured outdoor temperature is lower than the value
set in
Outdoor Temperature
, for the number of hours
set in
Delay (hours)
.
The zone switches from MELTING to IDLE state when
no moisture has been detected (for the number of
days set in
Delay Surface Dry)
, when the outdoor
temperature is higher than the value set in Outdoor
Temperature, and when the ground temperature is
higher than
Enter Melting State Conditions >
Ground Temperature Limit
.
MENU TREE
Enter Idle State Conditions
Outdoor Temperature
Delay (hours)
Delay Surface Dry
OUTDOOR TEMPERATURE
In this menu the outdoor temperature, used to switch
meltaway state from STOP or MELTING to IDLE, is set.
To set the outdoor temperature:
1. Select
Outdoor Temperature
.
2. Press the navigation wheel to confirm selection.
3. Set the value.
Default: 5.0 ˚C
Setting range: 0.0 – 15.0 ˚C, 0.1 ˚C increments
4. Confirm the new setting by pressing the navigation
wheel again.
EN
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
8 9
U P O N O R S M AT R I X M O V E P R O · I N S TA L L AT I O N A N D O P E R AT I O N M A N UA L
