5.8 Connect valve actuators to the
controller
The controller can control up to 4 different zones.
The illustration below shows actuators connected to the
controller.
1
3
2
4
42
+
-
+
-
+
-
-
+
45
48
50
43
46
49
51
X-159
W
arning
!
Electrical installation and service behind
secured 230 V AC covers must be carried
out under the supervision of a qualified
electrician.
N OT E !
Only the control signals from the vavle
acutators are connected to the Move PRO
controller. Power must be obtained from an
external source.
To connect valve actuators to the controller:
1. Ensure that the power is disconnected from both
the controller and the actuator.
2. Remove the terminal cover.
See section 5.6 Terminal cover for more information.
3. Study the wiring diagram to locate the connection
terminal positions.
4. Connect the wires from the actuator to the
controller.
ZONE 1:
• 0...10 V wire to terminal 43.
• Ground wire ( ) to terminal 42.
ZONE 2:
• 0...10 V wire to terminal 46.
• Ground wire ( ) to terminal 45.
ZONE 3:
• 0...10 V wire to terminal 49.
• Ground wire ( ) to terminal 48.
ZONE 4:
• 0...10 V wire to terminal 50.
• Ground wire ( ) to terminal 51.
5. Tighten the screws fixing the wires to the connector.
EN
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
2 5
U P O N O R S M AT R I X M O V E P R O · I N S TA L L AT I O N A N D O P E R AT I O N M A N UA L
