Uniwide Technologies XtremeServer 1322, User Manual

Page: 81 / 100

Advanced Configuration
Press <Enter> to enter the sub-menu screen for advanced configuration.
Reset SCSI Bus at IC Initialization
Selecting [Enabled] will reset the SCSI bus the first time the SCSI controller is
initialized.
Setting options: [Enabled], [Disabled].
Display <Ctrl><A> Message During BIOS Initialization
When enabled, the message "Press <Ctrl><A> for SCSISelect(TM) Utility" appears
on the screen during bootup. If disabled, the message does not show up, but you
can still press <Ctrl> + <A> key combination to enter the SCSI BIOS utility.
Setting options: [Enabled], [Disabled].
Extended Int 13 Translation for DOS Drives > 1 Gbyte
The field allows SCSI hard disk drives greater than 1 GB to use a translation
scheme of 255 heads, 63 sectors per track.
Setting options: [Enabled], [Disabled].
POST Display Mode
The field determines how much information about your SCSI controller and devices
appear on the screen during bootup. For the most complete information, choose
[Diagnostic]. For a faster boot, select [Silent].
Setting options: [Verbose], [Silent], [Diagnostic].
SCSI Controller Int 13 Support
The field allows you to enable or disable the support for Int 13h. The software
interrupt "Int 13h" is the interface through which the operating system or application is
able to pass commands to hard disk drives, such as reading, writing and formatting.
Setting options: [Enabled], [Disabled: NOT scan], [Disabled: scan bus].
79