37
Two ports are provided on the right side of the system for interface with a computer, a serial and a
parallel port. Only one port can be used at a time. To activate a port, select
PORTS
from this menu
and one of the following sub menus will appear:
or
The menu that appears indicates the currently active port on the laser system. To switch to the other
port press the
SELECT
key. In order to use the
SERIAL
port the communication settings
MUST
match those of the computer. Refer to the computer’s hardware and software manuals for details on
setting up the computer’s serial port.
If using the
SERIAL
port, select the fastest possible
BAUD
rate for communication since this effects
how quickly the computer can send files to the laser system. For
BAUD
rates of
9600
and above, set
the number of
STOP
BITS
on the computer to a higher value than the number of
STOP
BITS
selected
on the laser engraving machine. For example if the number of
STOP
BITS
on the laser engraving
system is set to
1
, then set the computer’s stop bits to 1.5 or 2.
PARITY
of the laser system and the computer
MUST
match exactly and the choices are
ODD
,
EVEN
, or
NONE
. Pressing the
SELECT
key while the cursor is on
PARITY
will toggle through
these choices.
Summary of Contents for ULS-25
Page 3: ...3 APPENDIX E SOFTWARE ANOMALIES E...
Page 14: ...14 Sample Exhaust System Layouts...
Page 62: ...62...
Page 82: ...A APPENDIX A WARRANTY...
