18.Interface
134
18-3-2. Character Length
Set the data and stop bits out of the following.
(Expression is in the order of data-stop bits.)
Setting item: 8bit-1stop / 7bit-1stop / 8bit-2stop / 7bit-2stop
18-3-3. Parity
Set the parity bit out of the following.
Setting item: None / Odd / Even
18-3-4. Terminator
Set the terminator out of the following.
Setting item: CR+LF / CR
18-3-5. Communication Mode
Set the communication mode out of the following.
(For each mode, see "18-4-12. Automatic Transmission Mode" P149.)
Setting item: Normal / Continuity / Hold Point
18-3-6. SI/F Hold Point Transmission
Set whether or not to output hold data by SI/F automatic printing after completion of
sampling.
Setting item: Transmit / Not Transmit
18-3-7. SI/F Hold Point
Set the ordinal number of hold points to output for SI/F automatic printing.
Setting range: 1 ~ 9
These settings are determined when the power is on. Therefore, if any
setting is changed, turn the power off and then on again.
Request
When the hold function is used at the
±
OVER and ADC
±
OVER, the
hold value will be
±
9999. While instead of
±
OVER or ADC
±
OVER,
the
±
9999 will be transferred via SI/F interface.
