16.Code Setting
100
16. Code Setting
Set the items used in each Operation Mode only the items necessary for the set
Operation Mode are displayed.
(See "3-2. Setting Mode Tree Chart" P15.)
16-1. Method of Setting the Operation ch
The operation ch can be set by external signals or the Auto Code Up function. Also, an
interval of approx. 40msec is required for switching the operation ch. (Switching within
approx. 40msec is ineffective. Operation ch switching processing is performed approx.
40msec after switching.)
1. Setting by external signals
(Processed by addition of the numerical value at the " ~ " part of CODE ~ .)
・
In the Waveform Comparison / Waveform and Displacement Comparison mode, the
operation ch of 16 or more is totally processed as 15ch.
・
The operation ch is taken in by double reading. For avoiding the delay at change-time,
use the STROBE signal, change the code beforehand, and turn off STROBE by the
timing of changing the operation ch.
2. Setting by the auto code up function
The operation ch can automatically be updated during sampling by using the Auto Code
Up function.
・
The Auto Code Up mode is executable when the Multi-Hold / Hysteresis mode is set.
・
If the Auto Code Up (See "16-2-5. Auto Code Up / Code Up Point" P107.) is set to
"ON" on the operation ch at which sampling starts, the sampling is brought into Auto
Code Up mode.
Operation
ch
CODE16
CODE8
CODE4
CODE2
CODE1
CODE1 ~ 16
0
：
Open
1
：
Short
0
0
0
0
0
0
1
0
0
0
0
1
2
0
0
0
1
0
3
0
0
0
1
1
・
・
・
・
・
・
・
・
・
・
・
・
・
・
・
・
・
・
31
1
1
1
1
1
