Unipower Sageon Shield 103-4023-01, Installation & Setup Manual

Page: 5 / 38

Sageon Shield Standalone Battery Monitor
PM990-4023-01, Issue 4 iii
TABLE OF CONTENTS
1. INTRODUCTION .............................................................................................................................................1
2. INSTALLATION ..............................................................................................................................................1
2.1. MOUNTING THE POWER SHELF .........................................................................................................1
2.1.1. Tools Required for Installation ...........................................................................................................1
2.1.2. Gaining Access to Wiring...................................................................................................................2
2.2. TEMPERATURE SENSORS.....................................................................................................................4
2.3. ALARM RELAY CONNECTIONS ..........................................................................................................4
2.4. CONTROLLER POWER CONNECTIONS ..............................................................................................5
2.5. FRONT PANEL USB COMMUNICATIONS CONNECTION ...............................................................5
2.6. REMOTE COMMUNICATION CONNECTION .....................................................................................5
3. CELL MONITORING BOARD ........................................................................................................................6
3.1. MAIN FEATURES OF THE SBM BOARD .............................................................................................6
4. SPECIFICATIONS ............................................................................................................................................6
5. INSTALLATION OF SAGEON BATTERY MONITOR BOARD .................................................................7
5.1. PREPARING THE BATTERY FOR CONNECTION TO THE SBM ......................................................7
5.2. BATTERY CELL LEAD CONNECTION TO THE SBM ........................................................................8
5.3. DIP SWITCH SELECTION OF CELL VOLTAGES..............................................................................17
5.4. DIP SWITCH SELECTION OF ADDRESS ...........................................................................................17
5.5. SYSTEM SETUP FOR SBM ...................................................................................................................17
5.5.1. Relationship between “SBM Batteries” and “Num Batteries” .........................................................17
6. SAGEVIEW SETUP .......................................................................................................................................18
7. SETTING UP NETWORK INTERFACES.....................................................................................................27
7.1. PROGRAMMING IP ADDRESSES USING DEVICE INSTALLER SOFTWARE .............................27
7.1.1. Preparations for local address set up ................................................................................................27
7.1.2. Local IP address set up procedure ....................................................................................................27
7.1.3. Preparations for gateway address set up ...........................................................................................27
7.1.4. Gateway IP address set up procedure ...............................................................................................28
7.2. PROGRAMMING IP ADDRESSES USING ARP AND TELNET ACCESS ........................................28
7.2.1. Preparations for local address set up ................................................................................................29
7.2.2. Local IP address set up procedure ....................................................................................................29
7.2.3. Configuring the Unit .........................................................................................................................30
7.2.4. Server Configuration (Network Configuration) ...............................................................................31