Uninterruptible Power Supplies PowerWave 3000T, User Manual

Page: 33 / 60

UPS469-01-00 PowerWAVE 3000T User Manual Dated 05-04-13
4-3
4: Operation
ON/OFF Start-up and shutdown buttons
The UPS may be switched ON or OFF by simultaneously pressing both
ON/OFF
keys on the control panel.
This is to prevent accidental UPS start-up or shutdown.
Note: When the UPS is under normal operation, pressing the two
ON/OFF
buttons simultaneously will
immediately shut down the UPS and disconnect the UPS from the load.
4.3 Description of the LCD display
4.3.1 Status screens
4.3.2 Main menu screen
CAUTION: If the
ON/OFF
buttons are operated while the UPS is not in Maintenance Bypass it
will interrupt the load power supply.
DESCRIPTION LCD-DISPLAY
1. Load is protected by UPS power supplied by inverter (normal operation).
LOAD
PROTECTED
2. Load is not protected by UPS power –supplied by mains power (load on
bypass)
LOAD
NOT PROTECTED
3. Load supply interrupted. UPS has been switched off by “
ON/OFF
”
buttons.
LOAD OFF
SUPPLY FAILURE
4. The UPS/module is not supplying load.
The output switch is open.
LOAD DISCONNECTED
OUTPUT SWITCH OPEN
DESCRIPTION LCD-DISPLAY
1. A log of the last 64 events is stored in the Power Management Display
(See paragraph 4.3.3) .
→
EVENT LOG
MEASUREMENTS
2. Allows monitoring of voltages, power, frequencies, currents, autonomy
etc
(See paragraph 4.3.4)
→
MEASUREMENTS
COMMANDS
3. Enables the commands “Load to inverter”, “Load to bypass” and battery
test to be executed
(See paragraph 4.3.5) .
→
COMMANDS
SET-UP DATA
4. Allows the UPS personalized information (such as serial number) to be
entered
(See paragraph 4.3.6) .
→
SET-UP DATA
SET-UP USER
5. Allows user to set up Date/Time, automatic battery test, etc.
(See paragraph 4.3.7)
→
SET-UP USER
SET-UP SERVICE
6. Password-protected area for service engineer use only (See paragraph
4.3.8) .
→
SET-UP SERVICE