Uninterruptible Power Supplies PowerWave 3000T, User Manual

Page: 31 / 60

UPS469-01-00 PowerWAVE 3000T User Manual Dated 05-04-13
4-1
4
Operation
4.1 Commissioning
The PowerWave 3000T UPS must be commissioned by a fully trained and authorised Uninterruptible Power
Supplies Ltd. field service engineer before being put into use. Commissioning involves connecting the
battery, checking the electrical installation and operating environment, performing a controlled start-up and
testing of the UPS system, and customer basic training.
4.2 Control Panel
The user-friendly control panel is composed of three parts:
• Power Management Display (PMD)
• Mimic LED Indicators
• Operating keys
Figure 4.1 Control Panel
4.2.1 Power Management Display (PMD)
The 2 x 20 character LCD Power Management Display simplifies communication with the UPS and also
provides UPS monitoring information
(See paragraph 4.3) .
The menu driven LCD enables the access to:
• The ‘Event register’
• Monitoring the input and output voltage, current, frequency & power
• Monitoring battery run time
• Perform commands such as UPS start-up and shut-down, Load transfer from INVERTER to BYPASS
and vice-versa
• Diagnostic (service mode only)
• Adjustments and testing (service mode only)
WARNING: Any PowerWave 3000T UPS system not commissioned by an Uninterruptible
Power Supplies Ltd. approved service engineer must be considered an electrical hazard, and
Uninterruptible Power Supplies Ltd. accepts no responsibility for its safe operation or the
safety of its operator. Additionally, the manufacturer's warranty will be immediately invalidated
if the UPS is put into use before it has been correctly commissioned.
Power Management Display (PMD) Mimic LED Indicators Operating Keys