iColor
LF700
Manual Version 3.6
Uninet
Copyright 2014
Page 43
Pen installation
The
LF700
cutters can also be operated with a plotter-type pen. After replacing the knife with a pen, the
cutter can be used as a plotter to draw draft plots of new or existing designs on paper.
1.
Loosen the head clamp screw, and then remove the tool from the clamp.
2.
Install the pen in the clamp and tighten the clamp screw.
3.
The change of tool can either be input on the control panel or with Summa Cutter Control (PC only),
or with the cutting software. Selecting pen operation disables the knife offset correction, and changes
the pressure to “pen pressure.”
The information on the LCD shows the tool currently selected by the cutter. Make sure the
cutter’s tool setting matches the actual tool in use.
OPOS Automatic Rise and Fall
The OPOS registration system is designed to rise and lower automatically during the registration and cutting
processes, this helps the user to keep the sensor clean to allow perfect registration and cutting throughout
production.
The user will still need to check that the sensor is in its lower position to aid this operation.
This setting can be toggled on or off in case the user needs to maximise production speeds, as this function
adds around 1 second to every re-registering process.
To turn on or off, select the key and locate the OPOS Up and Down setting by pressing , select the
required setting by pressing the key.
Some early model machines may not have this function enabled, please contact your local
dealer for details.
Maintenance on the OPOS still needs to be carried out to maintain cut accuracy.
Summary of Contents for iColor LF700
Page 1: ...i C o l o r L F 7 0 0 ...
