If you want to program tones for several stored frequencies, follow these steps:
After you program a CTCSS tone with a stored frequency, the CTCSS Tone Search Mode
is canceled. The CTCSS indicator remains on but does not flash. To activate the CTCSS
Tone Search Mode again, press and hold
K
until you hear two short beeps.
If you decide to cancel the CTCSS Tone Search Mode while scanning, press and hold
K
until you hear two short beeps and the CTCSS indicator turns off.
You can select the CTCSS Search Mode before pressing
s
. Simply, press and hold
K
until the CTCSS indicator begins flashing, and then press
s
.
When your scanner stops, the CTCSS Tone Search begins immediately. If a tone is found
before the transmission ends, press
e
to program the tone with the frequency stored in
the channel.
Using CTCSS Tone Search While Searching
1.
Set a Search Range.
For information about setting a search
range, see Setting a Search Range on
page 30.
2.
Press
S
.
3.
Press and hold
K
until you hear two
short beeps.
CTCSS
begins flashing in display.
The scanner starts searching for an
associated CTCSS tone when it stops on
a transmission. All 38 tones are checked
if the transmission is long enough.
However, if you press
h
, and there is
break before a tone is identified, the tone
search starts where it left off when the
transmission begins again.
SCAN
MANUAL
PRI TRUNK DATA
L/O
DELAY
CTCSS
1
2
4
7
5
8
0
3
6
9
E
35
