4.
Enter the frequency.
a. Enter the frequency number.
b. Then press
e
.
Note:
To clear a mistake while entering the frequency, press
.
twice, and start over.
If you enter a frequency which is outside
the scanner’s frequency bands, a
distinctive beep sounds.
The display will flash for a moment and
then reset itself, or you can press
.
and go back to the previous step.
See the Table on page 3 for information
concerning the frequency bands covered
by your scanner.
Programming using the Rotary Tuner
1.
Press
m
to stop scanning.
If the green LOCK LED is on, press LOCK to unlock the Rotary Tuner.
2.
Press
FREQ/CHAN
until the green
CHAN
LED lights.
3.
Use the Rotary Tuner to select the
channel you want to program.
4.
Press
FREQ/CHAN
until the red
FREQ
LED
lights.
5.
Use the Rotary Tuner to select the
frequency you want to program
Note: You can also enter the frequency
on your keypad.
SCAN
MANUAL
PRI TRUNK DATA
L/O
DELAY
CTCSS
1
2
4
7
5
8
0
3
6
9
E
a
b
16
