16
Heat stove extinction
To extinguish the heat stove
press the button for a few
seconds, until the upper
display reads
“OFF”.
The 5 available speeds may be scrolled by
pressing the power increase key
several
times. Set it to “0” to disable the fan.
In the case shown here the
hot air fan is off. The speed
in fact is set to “0”.
In the case shown here
the hot air fan is working
at speed 5, the maximum
available.
Press buttons and to respectively increa-
se and decrease the desired value.
Water temperature range: 30°C - 80°C
The pellets will immediately stop dropping while
the heat stove will continue operating until the
accumulated heat is completely exhausted, and
go out after 30 minutes at the most.
PLEASE NOTE:
The heat stove is equipped
with an automatism to clean
the burn pot after a certain
length of time: when this hap-
pens the flame is automati
-
cally lowered and the display will read
“PUL FIRE”
;
after a few minutes the heat stove will resume normal
operation.
The heating power is adju-
sted with buttons
and
. It is recommended
to set it at Po 9 for the first
hours of stove operation.
To adjust water temperature press button
once only.
The upper display will show the words "Set H2o"
flashing while the water temperature is shown on
the lower display.
To adjust the room
temperature press the
button
twice: the
lower display will show
the words "SET AIR"
flashing, whereas the set
temperature is shown on
the upper display.
Use buttons and to change the value.
Air temperature range: 7°C-40°C
Adjusting the work power and
water temperature
Room temperature adjustment
Hot air fan speed adjustment
The room fan located at the front of the stove may
be enabled or disabled.
The fan may be adjusted by selecting five different
operating speeds.
To adjust the hot air fan proceed as follows: press
button twice to access the room temperature
setting menu.
This adjustment is only required
for switching thermal ventilation on
and off as the temperature on grid
outlet depends on heat stove status.
Manual ignition procedure:
• open the door;
• take a cube of solid fuel and place it on the burn
pot together with a handful of pellets;
• strike a match and light the solid fuel inside the
burn pot;
• wait a few minutes, close the door;
• perform the normal ignition procedure.
Heat stove Cycle On/Off
