Ultrak CCU-100HD, User Manual

Page: 77 / 154

PROGRAMMING MULTICALLS
4-9
4.3.3.1 P - PreShot
To program the MultiCall to perform a PreShot, perform the following
steps.
NOTE
If the cursor does not automatically move to
the next field after entering data in a field,
press the gray right arrow key to move to the
next field.
1. Enter P in the FUN field .
2. Enter the desired PreShot Number (00-99) in the NUM field.
3. Enter the Camera Number (1-128) where the PreShot is stored in
the CAM field .
4. Enter a transit time (0.0-9.9 seconds) in the MISC field .
The transit time is the amount of time you want the camera to take
to move from its present location to the PreShot position. The
CCU-100 sends the transit time out to the SmartScan unit.
5. Enter a dwell time (00-99 seconds) in the DWELL field.
Dwell time is the amount of time you want the CCU to wait before it
performs the next step in the MultiCall. A “00” dwell time tells the
CCU to perform the functions at the same time. A “15” second
dwell time means that the CCU will wait 15 seconds before
performing the next step in the MultiCall. Note: The transit time
for a PreShot and the dwell time start at the same time.
6. Enter another function or press Enter to end programming. If you
pressed Enter, Press S to save programming or press Esc to end
programming without saving.