Ultrak CCU-100HD, User Manual

Page: 91 / 154

ASSIGNING MULTICALLS
4-23
4.3.10 Assigning MultiCalls to JPD-100 Function Keys
The CCU can be programmed to assign MultiCalls to JPD-100 Function
Keys. When the function key is pressed, the CCU starts the MultiCall
assigned to the key. When the function key is pressed again, the CCU stops
processing the MultiCall assigned to the key.
To assign MultiCalls to JPD-100 function keys, perform the following steps.
1. Press Shift F10 .
2. Press J on the KBD-100A Keyboard for JPD-100 JPD Quick Switch
3. Enter the address of the JPD-100 to be programmed
There can be up to four JPD-100 Controllers (0 through 3). The JPD-
100 front panel connection is JPD 0 and channels 1 through 3 on the
rear panel of the CCU-100 are JPD 1 through 3, respectively. Each
JPD-100 contains eight (8) function keys (quick switches).
The NUM column is the function key number and the MC column is the
MultiCall Number (0-255).
4. Use the gray arrow keys to move around in the table to assign a
MultiCall to the desired function key.
To unassign (remove) a MultiCall from a function key, press the space
bar until the MultiCall number is erased.
5. Press Enter when done.
6. Enter the address of another JPD-100 or press ESC to end
programming.