Ultimaker Original, Assembly Instructions Manual

Page: 37 / 109

Step 3: Mounting the caps Assembling the X/Y axes
37
3. Attach the wooden caps in corner C, see image 38.
The wooden caps WITH hole on the inside, the wooden end caps
WITHOUT hole on the outside.
Use ONE wooden end cap WITHOUT hole at the BACK panel.
5
Notice: Use ONE bolt M3 x 16mm and ONE hex nut 3mm at the RIGHT
panel.
5
Notice: Use ONE bolt M3 x 16mm and ONE hex nut 3mm at the BACK
panel,
image 38: attaching the wooden caps in corner C
4. Attach the wooden caps in corner D, see image 39.
The wooden caps WITH hole on the inside, the wooden end caps
WITHOUT hole on the outside.
Use ONE a wooden end cap WITHOUT hole at the LEFT panel
5
Notice: Use ONE bolt M3 x 16mm and ONE hex nut 3mm at the BACK
panel,
5
Notice: Use two bolt M3 x 16mm and two hex nuts 3mm at the LEFT
panel.