Ultimaker Original, Assembly Instructions Manual

Page: 20 / 109

Step 4: Preparing the BOTTOM panel Assembling the frame
20
1 x 1 x
4 x
4 x
image 13: parts needed for this step
To prepare the BOTTOM panel, perform the following actions:
1. Move 4 pieces black Velcro through the 4*2 slots of the
BOTTOM panel, see image 14.
Make sure the soft side is facing itself after placing.
2. Attach the Z-motor, see image 15.
Attach the motor such that the wires face out towards the center
of the BOTTOM panel.
3. Attach the coupling on the motor axis.
The 5mm opening of the coupling has to face towards the motor.
4. Tighten the screws, see image 16.
Make sure there’s a little space between the coupling and the
BOTTOM panel.
5
Use the 1,5 mm hex key as a guide.
D
A
B
C
E