Ultimaker Original, Assembly Instructions Manual

Page: 82 / 109

Step 4: attaching the feeder to the machine Assembling the material feeder
82
image 109: attaching the clamp assembly with U-Bracket and the lever on the main
body of the drive mechanism
The result must look like this, see image 110.
image 110: result after attaching the clamp assembly with U-Bracket and lever on the
main body of the drive mechanism
6.5.4. Step 4: attaching the feeder to the machine
To attach the feeder to the machine, perform the following actions:
1. Attach the feeder in the slots of the BACK panel, see image 111
2. Place the bow shaped tube in the tube couple of the material feeder
mechanism.
3. Secure the bow shaped tube with a blue horse shoe.
4. Move the wires from the material feeder through the hole below the
material feeder of the BACK panel.
5. Move the wires through the corner hole of the BOTTOM panel.