Ultimaker Original, Assembly Instructions Manual

Page: 36 / 109

Step 3: Mounting the caps Assembling the X/Y axes
36
To attach the wooden caps, perform the following actions:
1. Attach the wooden caps in corner A, see image 36.
The wooden caps WITH hole on the inside, the wooden end caps
WITHOUT hole on the outside.
5
Notice: Use two bolts M3 x 16mm and two hex nuts 3mm at both
panels.
image 36: attaching the wooden caps in corner A
2. Attach the wooden caps in corner B, see image 37.
The wooden caps WITH hole on the inside, the wooden end caps
WITHOUT hole on the outside.
5
Notice: Use ONE bolt M3 x 16mm and ONE hex nut 3mm at the RIGHT
panel.
5
Use two bolts M3 x 16mm and two hex nuts 3mm at the FRONT panel.
image 37: attaching the wooden caps in corner B