Ultimaker Original, Assembly Instructions Manual

Page: 23 / 109

Step 5: Assembling the ‘cube’-shaped frame Assembling the frame
23
2 x
2 x
37 x
37 x
image 17: parts needed for this step
Warning! Be careful not to put any force on the panels because they
are weak in this configuration; however they will become very sturdy
once you mount a few more panels.
To assemble to ‘cube’-shaped frame, perform the following actions:
(for action 1-5 see image 18)
1. Place the BACK panel on the table.
Make sure the markings are facing towards you.
2. Put the TOP panel, with the markings downwards, into the BACK panel.
3. Put the BOTTOM panel into the BACK panel.
5
The 3 holes in the top panel must be on the side of the back panel.
4. Put the FRONT panel in the TOP and the BOTTOM panel.
5. Attach the four panels.
Use thirteen bolts M3 x 16mm and thirteen hex nuts 3mm.
5
Notice: loose fixation is highly recommended. You can tighten later.
5
Notice: if you attach the hex nuts, it can be helpfull to use some tape
to keep them in position.
5
Notice: make sure no cables get jammed before tightening.
D
A B
C
E