50
1. PLACING THE Z STAGE INSIDE THE FRAME
To install all the Z stage parts in the machine, perform the following actions:
1. Place the frame on its back, with the bottom panel facing you.
2. Insert the two Z linear shafts through the holes in the bottom panel, until they are about halfway. Fig. 109.
3. Place the Z stage and Z stage cap in the frame and over the Z linear shafts. Fig. 110, 111 and 112.
4. Now insert the Z linear shafts completely and make sure they go into the holes in the top panel. The shafts should
not stick out of the bottom panel at all. Fig. 113 and 114.
This might take some force. Use a redundant piece of wood and a hammer to knock the shafts into place
if necessary.
110
109
112
111
114
113