36
Back X axle
To correctly place the back X axle, perform the following actions:
1. Take the other X axle (short).
2. Rotate the wooden cap without hole (right panel, back).
3. Insert the X axle through the right panel and move towards the left panel.
4. Place the following parts on the back X axle:
•
One timing pulley, with the thin side facing outwards. Place the long timing belt connected to the front X axle
around this pulley. Fig. 69.
•
The back sliding block. Make sure that the T-slot is facing inwards and the text is upright. Fig. 70.
•
One timing pulley, with the thin side facing outwards. Place the long timing belt connected to the front X axle
around this pulley. Fig. 71.
•
One timing pulley, with the thin side facing outwards. Place the short timing belt connected to the Y motor around
this pulley. Fig. 72.
5. Move the back X axle all the way into the left panel.
6. Rotate the wooden cap without hole (right panel, back) back to its normal position and secure with a bolt M3x16 and
a hex nut.
70
69
72
71