41
To correctly prepare the base plate, perform the following actions:
1. Place the aluminium plate in front of you, as shown on the pictures below.
2. Place the two linear bearings over the corresponding holes in the corners. Fig. 84.
3. Loosely secure them with four M4x10 bolts each, use the 2.5 mm hex key. Make sure that the bearings can still
move a little bit, you will calibrate them later. Fig. 85.
4. Place the golden lead nut in the hole in the middle of the aluminium base plate and secure with four M3x10 bolts
from the bottom of the base plate. Fig. 86 and 87.
85
84
87
86
