46
5. On the front two springs, place a glass retainer clip. Fig. 97.
6. Put the heated bed on top of the springs and secure with the three countersunk M3x20 bolts. Fig. 98 and 99.
Tighten the bolt and knurled nut in the back until there is approximately 1 mm of space between the bed’s
screw terminal and the aluminium base plate. Adjust the front two nuts until there is about equal tension
on the three springs. You will fine-tune this later. Fig 100.
7. Place the heated bed cable clip over the heated bed cable in the back left of the base plate and secure with two
M3x10 bolts. Fig. 101.
8. Open the glass retainer clips, slide the glass plate onto the heated bed and close the clips. Fig. 102.
98
97
100
99
102
86