35
First prepare all the pulleys by replacing the set screws inside the pulleys by the stainless steel set screws that are
separately supplied. Do not screw them in too far, the pulleys must be able to slide over the axles.
Front X axle
1. Take one X axle (short).
2. Rotate the wooden cap without hole (right panel, front).
3. Insert the X axle through the right panel and move towards the left panel. Fig. 63.
4. Place the following parts on the front X axle:
•
One timing pulley, with the thin side facing outwards. Place a long timing belt around this pulley. Fig. 64.
•
The front sliding block. Make sure that the T-slot is facing inwards and the text is upright. Fig. 65.
•
One timing pulley, with the thin side facing outwards. Place a long timing belt around this pulley. Fig. 66.
5. Move the front X axle all the way into the left panel. Fig. 67.
6. Rotate the wooden cap without hole to its normal position and fix with a M3x16 bolt and hex nut. Fig. 68.
64
63
66
65
67
68