ULS VLS Series, Service Manual

Page: 27 / 82

VLS Service Manual - REV2015.04
Table of Contents
Component Removal and Replacement
Page | 27
Component Removal and Replacement
6. Place the Lens Kit on a soft, non-abrasive cloth.
7. Remove the two Phillips head screws that attach the Beam Shaper to the Front Cover Plate and remove
the optic.
8. Attach the new Beam Shaper to the Front Cover Plate.
9. Clean the #3 Mirror, Focusing Lens, and Beam Shaper if necessary.
10. Reinstall the Lens Kit in the Focus Carriage.
Replace Beam Shaper (for HPDFO lens kit)
1. Make sure the VLS is powered OFF and unplugged.
2. Open the Top Door and pull the X-axis Arm forward.
3. Locate the Focus Carriage.
4. Remove the three thumbscrews completely. Set them aside in a safe place.
5. Slide the Lens Kit out of the Focus Carriage.