ULS VLS Series, Service Manual

Page: 13 / 82

VLS Service Manual - REV2015.04
Table of Contents
Adjustments and Settings
Page | 13
Adjustments and Settings
3. The rulers of the cutting table should overlap the rulers on the engraving table.
NOTE: The front left foot of the Cutting Table is offset. If you try to press both the front and rear left feet against
the Y-Axis ruler, the Cutting Table will not be square to the engraving table.
Cutting Table Calibration
NOTE:
Even with multiple lens kits, calibration on the Cutting Table is only required for one of them; the
calculation will be done automatically for all other optics sizes as long as they have been calibrated properly to
the engraving table.
1. Turn the VLS ON and lower the engraving table all the way down by using the
Home Z
feature.
2. Open the front door of the laser system and carefully slide the cutting table into the laser system so that
its rear feet are squarely pushed up against the engraving table rulers on the top and left side of the
table.