ULS VersaLaser VL-200, Safety & Installation Instructions

Page: 38 / 77

category from the material categories on the left (in this case wood) and then select the correct material
type from the material types on the right (in this case hardwood). Instead, if the material has already
been assigned an official VersaLASER Material Code, you can simply type in the code in the code field
and the correct material will be automatically highlighted from the database. Since we are placing the
material directly on the work surface, leave the Fixture Type set to Standard Table. If you were using an
optional accessory or custom fixture you would choose it from the fixture list. Using a calipers or similar
measuring device, enter the thickness of the material (in this case .125 inch). The Intensity control
allows you to increase or decrease the already pre ‐ programmed laser power setting. We suggest that
you always leave it set to “0” until you are more comfortable using the system. When you have made all
the appropriate selections and entered the material thickness, click PRINT. As the print job is being
created, a small printer icon will appear in your taskbar in the lower right corner of your computer
screen. Once the icon disappears the print job is completed and is now stored on your hard drive. Click
on the VersaLASER icon in the taskbar and the last print job will appear in the viewer of the VCP.
Step 3 – Powering On the VersaLASER
To power on the VersaLASER you can either left ‐ click on the POWER button in the VCP or press the
POWER button on the VersaLASER keypad. The VersaLASER will always reset itself in the X ‐ Y position
when it is powered on. However, the Z ‐ axis table will reset only when your computer is first turned on.
It will not reset each time you power on the VersaLASER.
1
2
1 0 2 3 4
I