- 18 -
6. Place the bicycle on the wheel rails and position the holder (2)
with the clamp (22) towards the bicycle frame. Secure the
bicycle against tipping.
7. Screw the clamp (22) to the bicycle frame with the twist grip (21).
8. Lock the holder (2) using the key (5) and then remove it.
9. Guide the lashing straps (25) between the middle of the wheel
spokes.
10. Thread the lashing strap (25) into the buckle (26) and tighten it.
11. Use the tensioners (24) to tighten the lashing straps (25) (arrow I).
Mounting the second bicycle
The second bicycle is mounted in the same manner as the first.
Note that the bicycles are mounted in opposite directions.
Mounting the third
2
and fourth
3
bicycles
The third and the fourth bicycle is mounted in the same manner as
the first. Note the opposite arrangement of all bicycles.
The third bicycle is attached to the second one with the holder (4).
The fourth bicycle is attached to the third bicycle using the second
holder (4).
Attention
Only attach the holder (2) to the bicycle frame, as other parts of
the bicycle could be damaged. Do not pinch components such
as gear or brake cables. Defective holders must be replaced
immediately.
Attention
Do not tighten the lashing straps (25) too firmly, otherwise the
tyres or rims could be damaged.
Note
The threaded rods in the holders must be regularly cleaned and
greased to prevent the twist grips from seizing up.
2
24
25
26
I
5
22
21
2 23
M+P-25A-0300
Attention
Only attach the holder (3) to the bicycle frame, as other parts of
the bicycle could be damaged.
Do not pinch components such as gear or brake cables.
Defective holders must be replaced immediately.
2 Uebler i31 S rack for 3 bicycles
3 Uebler i41 S rack for 4 bicycles
Attention
Only attach the holder (4) to the bicycle frame, as other parts of
the bicycle could be damaged.
Do not pinch components such as gear or brake cables. Defec-
tive holders must be replaced immediately.
3
M+P-25A-0216
4
M+P-25A-0217
