Ublox SARA-R4 Series, Command Manual

Page: 182 / 307

SARA-R4/N4 series - AT Commands Manual
UBX-17003787 - R09 18 Internet protocol transport layer
Page 182 of 307
18.3.2 Syntax
Type Syntax Response Example
Set AT+USOCR=<protocol>[,<local_
port>] +USOCR: <socket>
OK
AT+USOCR=17
+USOCR: 2
OK
Test AT+USOCR=? +USOCR: (list of supported
<protocol>s),(list of supported
<local_port>s)
OK
+USOCR: (6,17),(1-65535)
OK
18.3.3 Defined values
Parameter Type Description
<protocol> Number
• 6: TCP
• 17: UDP
<local_port> Number Local port to be used while sending data. The range goes from 1 to 65535. If the
parameter is omitted it will be set to 0; in this case a random port will be used while
sending data.
<socket> Number Socket identifier to be used for any future operation on that socket. The range goes
from 0 to 6.
18.4 SSL/TLS mode configuration on TCP USOSEC
+USOSEC
SARA-R410M-01B SARA-R410M-02B SARA-R410M-52B SARA-R412M Modules
SARA-N4
Syntax PIN required Settings saved Can be aborted Response time Error reference Attributes
full No No No < 1 s +CME Error
18.4.1 Description
Enables or disables the use of SSL/TLS connection on a TCP socket. The configuration of the SSL/TLS
properties is provided with an SSL/TLS profile managed by USECMNG.
The <usecmng_profile_id> parameter is listed in the information text response to the read command only if
the SSL/TLS is enabled on the interested socket.
This operation is only available for TCP sockets.
The enable or disable operation can be performed only after the socket has been created with +USOCR
AT command.
The SSL/TLS is supported only with +USOCO command (socket connect command). The SSL/TLS is
not supported with +USOLI command (socket set listen command is not supported and the +USOSEC
settings will be ignored).
SARA-R4 / SARA-N4
Issue the command before the
+USOCO AT command (socket connect command).
18.4.2 Syntax
Type Syntax Response Example
Set AT+USOSEC=<socket>,<ssl_tls_
status>[,<usecmng_profile_id>] OK AT+USOSEC=0,1,1
OK
Read AT+USOSEC=<socket> +USOSEC=<socket>,<ssl_tls_
status>[,<usecmng_profile_id>]
OK
AT+USOSEC=0
+USOSEC=0,1,1
OK
Test AT+USOSEC=? +USOSEC: (list of supported
<socket>s),(list of supported <ssl_
tls_status>s),(list of supported
<usecmng_profile_id>s) +USOSEC: (0-6),(0,1),(0-4)
OK